FYI

(Note: The origin of this information may be internal or external to Novell. 
Novell makes every effort within its means to verify this information. 
However, the information provided in this document is FOR YOUR INFORMATION
only.  Novell makes no explicit or implied claims to the validity of this
information.)

          TITLE:    Installing a Client
   DOCUMENT ID#:    FYI.P.6019
           DATE:    01OCT92
        PRODUCT:    NetWare Lite
PRODUCT VERSION:    All versions
     SUPERSEDES:    NA
 LITE FAX DOC #:    2653

SYMPTOM

     NA

ISSUE/PROBLEM

     Installing a Client

     To install NetWare Lite and configure your computer as a client, do the
     following steps.  Depending on your current setup, the installation
     program may skip some of the steps.

     1.   Insert the diskette labeled PROGRAM into the A: (or B:) drive.

     2.   Type A:INSTALL, and press <Enter>.

     3.   Verify that "Make this machine a client" is highlighted, and press
          <Enter>.

     4.   Type in the path of the directory where you want NetWare Lite
          installed, or simply press <Enter> to accept the default.  You may
          include the A: or B: drive letter if your computer does not have a
          fixed disk installed.  See Fax Document 2655 or FYI.P.6017 for more
          information on installing to a floppy diskette.

     5.   Insert the diskette labeled DRIVER into the A: drive, and press
          <Esc>.

     6.   Use the arrow keys to highlight the type of network board in your
          machine, and press <Enter>.  If you are not sure which board to
          choose, refer to the hardware documentation to determine what type
          of board you have or which interface it is compatible with.

     7.   A window showing default settings for your board is displayed.  You
          may change these if necessary by highlighting the item and pressing
          <Enter>, then highlight the correct value and press <Enter>.  Refer
          to the hardware documentation if you are not sure what the settings
          should be.  When the settings are correct, press <Esc>.

     8.   Answer YES or NO to the "path" message.  Note that if the C:\NWLITE
          directory is not in the DOS path, you will have to CD to it to use
          the NET utility.  You will also have to include the path for every
          NET command executed at the command line.


     9.   Answer YES or NO to the "lastdrive" message.  Note that LASTDRIVE
          should be set to the G: drive or higher to use the NET utility.  If
          you answer NO, you must edit the CONFIG.SYS file to include a
          LASTDRIVE command and reboot before you can use any NET command.

     10.  NetWare Lite is now installed.  Press <Esc> to exit the installation
          program.

SOLUTION

     NA